This document describes ValueRAM's 512M x 64-bit (4GB) DDR3-1600 CL11 SDRAM (Synchronous DRAM) 1Rx8, memory module, based on eight 512M x 8-bit FBGA components. The SPD is programmed to JEDEC standard latency DDR3-1600 timing of 11-11-11 at 1.5V. This 204-pin SODIMM uses gold contact fingers. #32The electrical and mechanical specifications are as follows:
â€¢ JEDEC standard 1.5V (1.425V ~1.575V) Power Supply
â€¢ VDDQ = 1.5V (1.425V ~ 1.575V)
â€¢ 800MHz fCK for 1600Mb/sec/pin
â€¢ 8 independent internal bank
â€¢ Programmable CAS Latency: 11, 10, 9, 8, 7, 6
â€¢ Programmable Additive Latency: 0, CL - 2, or CL - 1 cl 1ck
â€¢ 8-bit pre-fetch
â€¢ Burst Length: 8 (Interleave without any limit, sequential with
starting address â€œ000â€ only), 4 with tCCD = 4 which does not
allow seamless read or write [either on the fly using A12 or
â€¢ Bi-directional Differential Data Strobe
â€¢ Internal(self) calibration : Internal self calibration through ZQ
â€¢ On Die Termination using ODT pin
â€¢ Average Refresh Period 7.8us at lower than TCASE 85°C,
3.9us at 85°Câ€¢ Asynchronous Reset
â€¢ PCB : Height 1.180â€ (30.00mm), double sided component
Effective 1st April 2015, all goods and services may be subjected to GST 6% upon checkout.
subscribe and get special promotion updates
MCIL Multimedia Sdn.Bhd.(515740-D)
Copyright ©2016,Mykris Net MSC.
All Rights Reserved.